Concrete cutting in Auburn, AL - clean cuts planned around the steel inside
Need an opening, a section taken out or a round hole for a pipe? We scan first, then cut where the marks show it's clear.
- Licensed and fully insured.
- Free in-person estimates.
- We respond within 1 business day.
Concrete cutting that starts with a scan
Concrete cutting means sawing straight lines for an opening, a removal or a clean edge, and coring means drilling a round hole for a pipe. Most calls come when someone's widening a driveway or tying a new patio into an old slab. The cut's length and depth, the steel inside and the access set the price and the schedule, and your written estimate gives your figure.
Before we cut, we have the slab scanned and I show you the marks, so we know where the steel, tension cables and live lines sit. A cut tension cable lets go all at once and can bring the slab down, so the scan comes first. If the opening is structural, one field guide says the engineer of record must review it, so leave room in your schedule for that.
Ways we can cut your slab
Get a quoteStraight saw cuts
A saw cut makes a straight line for a doorway, a window well or a clean edge where new concrete will meet the old.
Coring round holes
A hollow diamond bit drills a neat round hole when you need to run a pipe or a conduit, or set an anchor, through the slab.
Wet cutting
Water keeps dust and heat down on long or deep cuts, and we contain the slurry because the city wants it kept out of drains.
Dry cutting
Dry cutting sets up faster and suits short cuts, or spots like an indoor floor where running water on the slab isn't practical.
More services
- Concrete driveway building
- Concrete patio construction
- Stamped concrete services
- Concrete sidewalk building
- Garage floor concrete
- Decorative concrete
- Concrete retaining walls
- Concrete floor installation
- Concrete pool decks
- Concrete steps construction
- Slab foundation building
- Foundation installation
- Concrete parking lot building
- Concrete footings
- Foundation raising
Tell us about the cut you need
Send the cut's location, length and purpose, such as a pipe hole or a removal, and we'll reply within one business day to set a time to look.
- Free on-site estimate
- Each choice explained in writing
- No obligation to book
Why Auburn owners call us to cut
I come out myself
I look at your slab in person before we price the job, and I'm on site with our crew the day we cut, so the plan we agreed on is the plan we follow.
Licensed and fully insured
We're licensed and fully insured for cutting and coring in Auburn and the cities around it, including Opelika, Valley, Smiths Station, Tuskegee, Lanett and Tallassee.
Permit questions settled early
The city's Inspection Services issues permits for alterations and remodels, so we ask early what your cut needs and file our part or show you yours.